What P0320 means
P means powertrain (engine and transmission). The 0 marks a generic code defined by SAE, so the same number means the same thing across makes. The third character, 3, places it in the ignition system or misfire subsystem; the last two digits identify the specific fault.
On older and distributor-based systems, the engine speed signal comes from the ignition module or distributor pickup rather than a dedicated crank sensor. The engine computer uses it for timing and fuel control.
What “Circuit” means here
"Circuit" is the broadest fault type in the standard. The module has found the ignition / distributor engine speed input circuit electrically unusable: the signal is missing, outside its electrical limits, or the module's own self-test of the circuit failed. Some vehicles set this instead of the more specific low/high codes; others set it alongside them. Either way the first suspect is the wiring and connector, then the component, and only then the module.
What you may notice
Symptoms depend on the vehicle and on how the module responds to the fault. Any of these can accompany P0320:
- Stalling or no-start
- Tachometer erratic
- Misfire or rough running
Where to start diagnosing P0320
- Inspect the distributor or ignition module connector and wiring.
- Check the pickup air gap and condition where adjustable.
- Confirm the signal with a scope during cranking.
Clear the code only after recording freeze frame data: it shows the engine speed, load and temperature at the moment the fault set, which is often the best clue to reproducing it.
Live data to watch
These standard OBD2 values relate to P0320. Support varies by vehicle; a value your car does not report will simply be missing.
| Value | What to look for |
|---|---|
| Engine RPM (PID 0x0C) | Should be steady at idle and present while cranking. |
Related codes
Codes from the same ignition / distributor engine speed input family. If several are stored together, the shared part — wiring, a common reference voltage, or the component itself — is the place to start.
Further reading
Frequently Asked Questions
What does P0320 mean?
P0320 is the generic SAE J2012 code for "Ignition/Distributor Engine Speed Input Circuit". In plain terms, it means the engine computer has detected a "circuit" fault on the ignition / distributor engine speed input.
Can I keep driving with P0320?
Can stall the engine without warning. Have it diagnosed before relying on the vehicle.
What should I check first for P0320?
Inspect the distributor or ignition module connector and wiring.
Definition source: SAE J2012 / ISO 15031-6 generic DTC definitions. This is the generic meaning that applies across makes; a manufacturer can define a code more narrowly or add its own sub-codes, so confirm against the service information for your vehicle before replacing parts. Written by the OBDAssistant engineering team — see our editorial policy.