U0111: Lost Communication With Battery Energy Control Module "A"

What U0111 means

U means network (communication between modules). The 0 after it marks a generic code defined by SAE rather than by the manufacturer, and the U01xx block is reserved for lost-communication faults with specific modules.

Modern vehicles connect their control modules on a shared data network, most often CAN bus. Each module expects regular messages from the others. A "lost communication" code is set by a module that stopped receiving expected messages from the named module for longer than an allowed time.

The module named here is the battery energy control module that manages a hybrid or EV high-voltage battery. What you notice depends on what that module does: hybrid/EV warnings or reduced performance. High-voltage systems need qualified service.

What “Lost Communication” means here

A module on the network expected periodic messages from the battery energy control module that manages a hybrid or EV high-voltage battery and did not receive them for longer than allowed. The code is stored in the module that noticed the silence, not necessarily in the one that went quiet, and the named module may itself be unpowered, faulty, or cut off by wiring.

What you may notice

Symptoms depend on the vehicle and on how the module responds to the fault. Any of these can accompany U0111:

• Warning lights for the system the missing module controls
• Features of that system not working
• Several U-codes stored at once in different modules

Where to start diagnosing U0111

1. Check battery voltage and the charging system first; low voltage causes many communication faults.
2. Check whether the named module is powered: its fuses, power feeds and grounds.
3. Scan all modules: if one module is silent to every other module, focus on it; if many modules are missing, suspect the network wiring.
4. Inspect network wiring and connectors near the named module; on CAN, the two termination resistors should measure about 60 Ω together across the bus pins with the battery disconnected.

Clear the code only after recording freeze frame data: it shows the engine speed, load and temperature at the moment the fault set, which is often the best clue to reproducing it.

Live data to watch

These standard OBD2 values relate to U0111. Support varies by vehicle; a value your car does not report will simply be missing.

Related codes

Codes from the same vehicle network communication family. If several are stored together, the shared network wiring, power supply or ground is the place to start.

Further reading

• Several warning lights came on together
• CAN bus architecture and network faults

Frequently Asked Questions